3.5mm Quadcopter Power Distribution Board


New product

Simply use the 3.5mm male connectors on your ESCs and plug a battery in. This PCB comes with a pre-soldered XT60 connector and also features a 2 pin JST size auxiliary power out.

More details

In stock!

By buying this product you can collect up to 5 loyalty points. Your cart will total 5 points that can be converted into a voucher of £ 0.10.

£ 5.69

Add to wishlist

More info


Quadcopter Power Distribution Board


This handy power distribution is the ultimate solution for tidy power distribution wiring and comes pre-soldered with an XT60 Connector.

If you are not using batteries with an XT60 plug on them, simply use an adapter with the approriate plugs, or solder your own connector on!

Simply use the 3.5mm male connectors on your ESCs and plug a battery into the main connector. This PCB is Gold plated for optimal efficiency and also features a bling port (aka 2 pin JST size auxiliary power out).

Perfect for powering LEDs or any accessory fitted to your Quadcopter.

Current: 4 x 20A Outputs (MAX)
Power Input: XT60 with 12AWG wire
Motor output: 4 x 3.5mm Female bullet plug
Aux output: 2 pin JST compatible
Weight: 27.3g (including wires)


3 other products in the same category: